EvilNuff Posted February 6, 2015 Report Posted February 6, 2015 I have a Harmony Touch remote that is set up following the FAQ for harmony remotes here. I have a flirc updated to firmware v3. I cannot get the remote to do any actions at all in XBMC. I have gone into the actions on the harmony remote software and verified that the remote buttons are doing the XBMC actions that I desire but when I use them there is no response. I can go into the Flirc software, full keyboard and learn keys which it says are successfully learned from the remote so I believe the flirc is functional. It can obviously receive signals from the remote. I can verify that the signals are correct via a bluetooth keyboard. Yet when I use the remote buttons nothing happens. I have the XBMC setting selected that remote sends keyboard signals. I have looked around online but can find nothing that actually gets flirc to work. Any help is appreciated. Quote
jason Posted February 6, 2015 Report Posted February 6, 2015 Do you have built in profiles enabled in the gui? Quote
EvilNuff Posted February 6, 2015 Author Report Posted February 6, 2015 I do have them enabled yes. However, it appears that I fixed the problem by rebooting the htpc again. After a reboot it started receiving the signals. :wub: Quote
jason Posted February 6, 2015 Report Posted February 6, 2015 Could have been that the gui was still open Quote
pmcd Posted June 30, 2015 Report Posted June 30, 2015 When you follow the guide for a Harmony and then you added the Open Kodi command by teaching from the Panasonic remote had the Panasonic button already been taught to Open Kodi? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.