April 16, 20242 yr comment_35507 When I am programming Skip, I test actions (specifically power on a Pioneer vsx1021 receiver), and works great, but when I disconnect Skip from my Mac, Skip couldn't turn on or off the pioneer receiver. I tried with new batteries, and same results. Report
April 16, 20242 yr comment_35508 18 minutes ago, gdenicolas said: When I am programming Skip, I test actions (specifically power on a Pioneer vsx1021 receiver), and works great, but when I disconnect Skip from my Mac, Skip couldn't turn on or off the pioneer receiver. I tried with new batteries, and same results. This is a new one. Do the lights turn on when disconnected from the computer? Like in the profile buttons and the color ring? Report
April 16, 20242 yr Author comment_35510 Lights turn on after disconnected. Maybe with a little bit lower brightness. I have tried with two different pairs of new batteries. Report
April 16, 20242 yr comment_35511 11 minutes ago, gdenicolas said: Lights turn on after disconnected. Maybe with a little bit lower brightness. I have tried with two different pairs of new batteries. Nah, not the batteries then. Can you save your configuration file and post it here. Can you also tell me what firmware version you have on your remote? Report
April 17, 20242 yr comment_35524 Okay, firmware is most likely the issue. Remove the batteries. Press the center key and the back key at the same time while plugging in the USB. You should see the lights blink red if you press any button, if not, didn't work. Launch the app, it will upgrade the firmware. If not, let me know. Report
April 17, 20242 yr Author Solution comment_35529 it didn't work. I switch from "power on" to "power toggle" , for the Pioneer vsx-1021 receiver, and it worked. Thanks for your support. Report
April 18, 20242 yr comment_35537 19 hours ago, gdenicolas said: it didn't work. I switch from "power on" to "power toggle" , for the Pioneer vsx-1021 receiver, and it worked. Thanks for your support. You are on the latest now? What is the firmware version now? Report
April 18, 20242 yr comment_35538 19 hours ago, gdenicolas said: it didn't work. I switch from "power on" to "power toggle" , for the Pioneer vsx-1021 receiver, and it worked. Thanks for your support. Thanks for letting me know it worked, but let me know the firmware version so that I can try to reproduce and get to the bottom of it. Again, thanks for letting me know. Report
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.