I have tried a couple of times to upgrade firmware. It always says complete but then it never actually updates. Every time I open the app it says it needs to update firmware again. I'm hoping this will fix an issue with the power button mapping not working. 

Same happens to me with my v1 Flirc, it seems to go through the upgrade and afterwards still says I have v3.11

Same here. The Flirc UI 3.25.2 is asking me to upgrade my old generation Flirc ( in transparent case ) from 3.11 to 3.12 But after successful flashing it stays on 3.11

Same problem here on 2 x gen1 devices - stuck on 3.11

Same here on all accounts.

Flirc v1 & Streacom each can't upgrade to 3.12

+1 for this issue.

flirc v1 upgrade from fw 3.11 to 3.12 reports as successful but disconnecting and reconnecting reports that fw is still 3.11. 

I attempted to manually update using fw 3.12 bin file posted in another thread by @jason. This results in an error to contact support. If I close and reopen the gui it tries to resume the fw update. The gui then reports it is successful but once again 3.11 remains.

 

On 1/24/2020 at 9:46 PM, jaykass said:

+1 for this issue.

flirc v1 upgrade from fw 3.11 to 3.12 reports as successful but disconnecting and reconnecting reports that fw is still 3.11. 

I attempted to manually update using fw 3.12 bin file posted in another thread by @jason. This results in an error to contact support. If I close and reopen the gui it tries to resume the fw update. The gui then reports it is successful but once again 3.11 remains.

 

There is no 3.12, I'll push an update to address this. Sorry about that.

3 hours ago, jason said:

There is no 3.12, I'll push an update to address this. Sorry about that.

Looks good. 

Thank you. 

12 hours ago, jaykass said:

Looks good. 

Thank you. 

Awesome, thanks for letting me know. Sorry everyone.