ok so I have got it working now. In the CLI, i changed the delay to 1. The noise option i had enabled but this didn't allow me to move around at all (non responsive). So I disabled it again (as it is at default). It works fine now with no repeating. It is a tad slow... so I put it up to 2 on the delay, and the issue appeared again. So I am sticking where I am now.
So this is my setup...
- latest firmware. Did not program any buttons.
- in CLI just edited the delay from 6 to 1.
- Using harmony 650 with Flirc device via myharmony in my activity.
I think if the CLI commands can be put into the GUI this will help a lot. More info one the options too would be good.