adishtrt Posted May 31, 2015 Report Share Posted May 31, 2015 I buy my FLIRC a few months ago and all good and well....today i wanted to upgrade the firmware and set the remote with the updated FLIRC.... it seems that for example, when i set my 2 key on the remote and select the number 2 on the "full keyboard" in the flirc app... and then select the 5 key on the remote it show me an error that the button is already exists.... i'm using the xtreamer ultra remote: https://shop.xtreamer.net/products/Xtreamer-Ultra-Remote-control.html thank you! Quote Link to comment Share on other sites More sharing options...
adishtrt Posted June 4, 2015 Author Report Share Posted June 4, 2015 :P Quote Link to comment Share on other sites More sharing options...
Chris! Posted June 4, 2015 Report Share Posted June 4, 2015 It's been a while since i've been the forum but I thought there was a similar issue that had a solution. Unfortunately I couldn't find that. If you open a text editor (or anything you can type text in): - when you press "2" on your remote what key is outputted on the screen? - when you press "5" on your remote what key is outputted on the screen? Just to check what key Flirc thinks already exists. today i wanted to upgrade the firmware and set the remote with the updated FLIRC.... After you upgraded, did you clear the configuration before reprogramming? https://flirc.zendesk.com/hc/en-us/articles/203361609-What-does-Save-Load-Clear-Configuration-mean- Quote Link to comment Share on other sites More sharing options...
Ingoping Posted December 25, 2019 Report Share Posted December 25, 2019 On 6/4/2015 at 1:20 PM, Chris! said: It's been a while since i've been the forum but I thought there was a similar issue that had a solution. Unfortunately I couldn't find that. If you open a text editor (or anything you can type text in): - when you press "2" on your remote what key is outputted on the screen? - when you press "5" on your remote what key is outputted on the screen? Just to check what key Flirc thinks already exists. After you upgraded, did you clear the configuration before reprogramming? https://flirc.zendesk.com/hc/en-us/articles/203361609-What-does-Save-Load-Clear-Configuration-mean- nothing is shown on the screen. The B&O Controller is attached with software to an IR output Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.