Jump to content
Flirc Forums

Search the Community

Showing results for tags 'programming'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Flirc forums
    • Getting Started with Flirc
    • General Questions
    • How To
    • Show Off
    • Remote Controls
    • Ideas and Suggestions
    • Bugs

Found 3 results

  1. Failure: Button already exists

    I have a problem while programming my flirc. I am able to program 4 or 5 keys, but after a few keys the failure-message is shown, that the key is already programmed. I have no chance to redo it, because the message won't dissapear. I have two flirc. One 1st gen and the new one 2nd gen. I have had no problems while programming the 1st gen one. Maybe there is a problem with the firmware or the software? I have already updated the firmware but no change.... Maybe anybody can help me with this problem...
  2. Flirc programming

    Hello, I'm a newbie and I bought a flirc 2gen to extend my wetek hub functionality. It is sitting next to my cubox-i. Problem is I control my cubox-i with a MCE windows remote and Flirc receive those commands. I'd like flirc to receive only instructions from the remote I used to acquire commands so remote of one device doesn't mess with other device. Is that possible? Thanks Giorgio
  3. Unable to reset Flirc

    I hope to use Flirc with Raspbmc but am new to Raspbery Pi and do not know how to download the Flirc program. I tried to program Flirc on a Macbook Air using an EyeTV remote. I keep getting "Button already exists - Start Over, Skip, Redo". I tried all three choices - no help. I tried "Clear Configuration" - no help. I tried "Erase" - no help. HELP.
×