Import codes

[V_J]

Hello,

Is it possible to edit the configuration file and just load the codes from e.g. https://files.remotecentral.com/ rather than learning each code? If so, what should be the format of the code (the hex codes, such as here: https://www.remotecentral.com/cgi-bin/codes/marantz/receiver_0/ ?

(I plan to use Flirc together with an ethernet-IR bridge, so I don't really have a remote to learn from. At the same time, I cannot use profiles as I want the numpad keys. I could try the learing procedure using the bridge as transmitter, but that would take a lot of time as I would need to enter the codes one by one in the transmitter)

Thanks!

Jörg

Edited July 15 by V_J

[gorgeous]

 

On 7/16/2024 at 2:47 AM, V_J said:

Hello,

Is it possible to edit the configuration file and just load the codes from e.g. https://files.remotecentral.com/ rather than learning each code? If so, what should be the format of the code (the hex codes, such as here: https://www.remotecentral.com/cgi-bin/codes/marantz/receiver_0/ ?

(I plan to use Flirc together with an ethernet-IR bridge, so I don't really have a remote to learn from. At the same time, I cannot use profiles as I want the numpad keys. I could try the learing procedure using the bridge as transmitter, but that would take a lot of time as I would need to enter the codes one by one in the transmitter)

Thanks!
friday night funkin'

Yes, it is possible to use pre-existing IR codes, such as those available on remote central, and integrate them into a configuration file to be used with devices like Flirc and an ethernet-IR bridge.