April 24, 201412 yr comment_6859 I just got my flirc and it came with firmware 2.0. My remote is the Harmony Ultimate and while I could record my remote buttons I was having trouble as it seemed the direction arrow up and direction arrow right were sending the same command. I upgraded my flirc firmware to 2.4 and cleared the configuration to start again and now I cannot record any remote commands at all. Can I revert to an earlier firmware? Report
April 25, 201412 yr Author comment_6867 Thank you for the reply, however the only download link on the page for firmware give a page not found error. Is there another way I can get a copy of firmware earlier than 2.4? Report
April 25, 201412 yr comment_6871 What error are you getting when you try to program a button? Button Already Exists, or, Not Room For New Buttons? http://forum.flirc.tv/index.php?/topic/1058-unable-to-reset-flirc/?hl=firmware#entry6779 I'm still looking for the firmware stuffs. Do you have the XBMC Profile activated? From what I've read it's paired to the Harmony One, specifically, so the codes pre-programmed in may be mish-mashed codes of what your Harmony Ultimate is sending out. Report
April 28, 201412 yr Author comment_6880 Thanks for the reply. I get button already exists, but nothing works when I try it. I have profiles disabled and am trying to use the full keyboard controller Report
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.