Jump to content
Flirc Forums

Search the Community

Showing results for tags 'driver issue'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Flirc forums
    • Skip
    • Raspberry Pi Cases
    • Flirc USB
    • Flirc USB Gen1
    • Jeff Probe

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


Location


Interests

Found 2 results

  1. Dear Sir/Madam, I have been using a FLIRC Gen 1 to enable an old universal remote to control Kodi on my Raspberry Pii for a number of years. I have just replaced my controller with a One For All Essence remote and need to reprogram the FLIRC keys, which I haven't needed to do for a long time. I have connected the Flirc to a Windows 10 Home pc but device manager showed it could not find the driver. I followed an older forum post to resolve (https://support.flirc.tv/hc/en-us/articles/200712548-Using-the-ZADIG-Utility) using ZADIG, which enabled me to install a working driver. However when I install the latest app it shows the FLIRC as being disconnected. I have tried on two different windows 10 PCs now and it is the same on both. Please can you assist? (NOTE: I'm not very techy so may need a more detail instructions or advise than most). Many thanks in advance.
  2. Hi all, about a week ago I bought the Flirc usb device, and it worked flawlessly until today. I use the flirc with a Logitech Harmony One remote, to control my (Windows 10) media-pc with Kodi. I was close to a perfectly working system, but had to make two small adjustments. So, I started the software, and was asked to update the software v3.25.0 (from 3.24.3); the firmware was also upgraded. After that, the flirc did not respond to any keystroke from my remote. The system management of Windows 10 showed a USB-device, with an error message: 'could not start'. Before the crash, a Flirc device was listed (as far as I know) I re-installed software, drivers, and tested everything on another pc, but without any result. So, in one instance a wonderful device became completely useless. I even tried an old trick with Zadig software, but that did not work either. A solution would be much appreciated, as a working flirc is really a great device. A firmware downgrade could probably do the job (but I have no access to older firmware, and means to install it), but other solutions are of course also very welcome. Hope to hear from you soon Adri
×
×
  • Create New...