[Flirc presses keys without me using the remote]

Yes that's what i did without success.

 

I went to the toilet, no light, only the laptop with me, and I covered the FLIRC device completely with my hand. Then I started the software and the learn process was still detecting IR signals ! I repeated the process several times. The delay to detect ghost IR signals varied from immediate to a few seconds.

 

It looks like my unit is defective :/

 

Can you try to check one more time with distance 10-20m from any TV/Recievers ect. with notebook with flirc? 

[Flirc presses keys without me using the remote]

Hi all!

 

my solution was simply run away from all devices that can make IR-noise.. Simply go away in other room (my case it was bedroom) with notebook and "check the sound" for ghost key-presses. it must be quite (i mean no more key-presses). After that simple erase all and re-register Remote keys. All works perfect (have switched back from Win7 to raspberry pi simply by inserting flirc in pi)

[Flirc presses keys without me using the remote]

So i have checked with USBTrace and have following detected:

1. Starting Flirc-GUI pass trace messages in USBTrace

2. Pressing "Erase" -> Messages

3. Pressing button on remote in key-accept mode -> Messages

4. if i wait few seconds - GUI write "button already erased" , no messages in USBTrace

any advice? some kind conflicted software/drivers? msi350ai-e45 with Win7-32, flirc is used for XBMC

[Flirc presses keys without me using the remote]

Have the same issue! Have tring to delete like you wrote, but i get always the same message "already deleteted".

Strange is - it was perfect workig unter ubuntu and just strange keypresses under Win7-32 (harware is the same). Firmware V1.