cardboardpig

Jason, after reading your email I decided to use a third machine running Windows 8.1 x64 and a fresh install of Flirc to try the upgrade from a different USB chipset. I was unable to upgrade the Flirc initially, but after uninstalling and reinstalling the Flirc software a second time (and deleting drivers) I was able to upgrade the firmware... I didn't change anything between the first and second attempt so I'm not sure why it worked the second time. I was able to fix the second non-working Flirc the same way. The same procedure didn't work on the first two machiens. Furthermore as the USB drivers on the first two machines were fully up to date I can only assume the Flirc and their USB chipsets/drivers just don't get on together when updating firmware...?!

I ended up buying another couple of Flircs. I attempted to upgrade one of the new Flircs on a separate PC running Windows 7 x64 on a USB port and experienced a similar issue. Screenshots of the device manager from the two PCs: If I start the Flirc application on the Windows 8.1 machine with the Flirc plugged in it immediately crashes. USB drivers on both machines are up to date. The Windows 8.1 machine on which I did the initial upgrade recognises both non-working Flircs as "flirc bootloader" under libusbK USB Devices, while Windows 7 recognises them both as "bootldr" under Other Devices.

I've rebooted the original machine and reinserted the flirc and now I can see flirc bootloader in the device manager without an exclamation mark so it appears to have loaded properly. The application still crashes immediately on start though. Any ideas :(

Hi. I recently received a flirc and after installing decided I should upgrade the firmware from v1.0 to that suggested by the flirc application (v2.4 if memory serves). The operating system I used is Windows 8.1 x64 and I used a usb3 port (I have no usb2 ports on the machine). After clicking upgrade the application immediately crashed and under device manager is now only listed as bootldr with a yellow exclamation mark indicating the drivers for this device are not installed. Each attempt to run the application after this resulted in an immediate crash. After waiting 10 minutes or so (just in case!) I unplugged the flirc and plugged it into my Windows 7 x64 machine in a usb2 port and installed the flirc software. Unfortunately it also could not load drivers. Has this bricked my flirc? Is there a way I can recover from this? I have a linux machine I can use if that will make a difference. This is incredibly frustrating - I didn't do anything untoward, just attempted to update the firmware using the supplied application.