Jump to content
Flirc Forums

Problem setting up flirc after updating


adishtrt

Recommended Posts

I buy my FLIRC a few months ago and all good and well....today i wanted to upgrade the firmware and set the remote with the updated FLIRC....

 

it seems that for example, when i set my 2 key on the remote and select the number 2 on the "full keyboard" in the flirc app... and then select the 5 key on the remote it show me an error that the button is already exists....

 

i'm using the xtreamer ultra remote: https://shop.xtreamer.net/products/Xtreamer-Ultra-Remote-control.html

 

thank you!

Link to comment
Share on other sites

It's been a while since i've been the forum but I thought there was a similar issue that had a solution. Unfortunately I couldn't find that.

 

If you open a text editor (or anything you can type text in):

- when you press "2" on your remote what key is outputted on the screen?

- when you press "5" on your remote what key is outputted on the screen?

 

Just to check what key Flirc thinks already exists.

 

 

 

today i wanted to upgrade the firmware and set the remote with the updated FLIRC....

After you upgraded, did you clear the configuration before reprogramming?

https://flirc.zendesk.com/hc/en-us/articles/203361609-What-does-Save-Load-Clear-Configuration-mean-

Link to comment
Share on other sites

  • 4 years later...
On 6/4/2015 at 1:20 PM, Chris! said:

It's been a while since i've been the forum but I thought there was a similar issue that had a solution. Unfortunately I couldn't find that.

 

If you open a text editor (or anything you can type text in):

- when you press "2" on your remote what key is outputted on the screen?

- when you press "5" on your remote what key is outputted on the screen?

 

Just to check what key Flirc thinks already exists.

 

After you upgraded, did you clear the configuration before reprogramming?

https://flirc.zendesk.com/hc/en-us/articles/203361609-What-does-Save-Load-Clear-Configuration-mean-

nothing is shown on the screen. The B&O Controller is attached with software to an IR output

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...