Jump to content
Flirc Forums

Search the Community

Showing results for tags 'rc-commands'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Flirc forums
    • Getting Started with Flirc
    • General Questions
    • How To
    • Show Off
    • Remote Controls
    • Ideas and Suggestions
    • Bugs

Found 2 results

  1. I don't know if this is a kodi issue or a Flirc issue, but I will try here first. Last night my Pi3 with kodi (openelec) froze, where I had to do a hard reboot. After that my Harmony Ultimate would not work properly. Kodi no longer responded to the direction keys or the select key. It would back a noise if I pushed the Back button, and would respond to the Page Up and Page down buttons on the screens. I downloaded the updated Flirc app and updated the firmware, re-programmed the direction and select buttons, and returned the Flirc to the Pi 3, but the problem still persists. Is there anything else I can do, or is this a Kodi issue?
  2. A long time ago I wrote to you for help, and Mr. Chris and Mr. Jason were very kind to me. I have Windows 7 x64 Well, I have these two Flircs (you all sent me one of them for free back when I had troubles the first time) and they are a bit old; I think from 2015. I have installed the latest Flirc GUI and upgraded the firmware on my Flircs from 3.6 to 3.9. You can see that Flirc has the 3.9 driver. Neither of my Flircs respond to the remote control's commands. I can program the buttons just fine in the GUI But I'm getting this in the device log. In the Windows 7 Device Manager I see under Portable Devices the WPD FileSystem Volume Driver is in a warning state with "This device cannot start. (Code 10)". I tried uninstalling these drivers and re-inserting the Flirc, but it comes back to the same situation. I also see the Flirc Driver there under libusbK USB Devices; I tried uninstalling this too and deleting the device drivers. Is there something I can do?
×