DirtyRob

Ok. Thanks for the update. I figured as much. Thought I'd just check. I've got one on order anyways ... it looks like it'll work out great.

on this case revision note ... I saw on a pi case review that the heat sink was molded to the location of the RPI 1 chip location (RPI 2 and 3 are apparently shifted towards the power led end by a couple mm). The case on the site currently says it's built around RPI 2 dimensions (evident by the yellow Av input hole being gone ... No port openings on the io side of the case). Was the heat sink location adjusted? Have there been any revs to this design at all? Also on the note of the LEDs ... I don't have one in hand yet to check ... But the plastic bottom seems to be what blocks them, and is notched on the left a bit to reveal them. Some careful dremmel work on the opposing plastic corner should do the trick, no? Or are they too far over? It would be a cut mostly hidden anyways? I had an idea to use thick gauge fishing line leaders as fiber optic runs to those leds using a little super glue so they can be redirected a bit (dip them in black acrylic paint or something before cutting to prevent bleed over). That may all be going overboard though. But style was a huge selling point on this case for me, so its worth it to me to put a little extra in it. if anyone cares ... I'll post a pic of the final outcome when I'm through. I know there are other posts concerning this ... But they are a bit older (up to a year even). Just looking to see if anything has changed since then.