I'm using a Harmony 900 to control a FireTV (1st gen, gaming edition). Using the Flirc/FireTV device profile in Harmony all the standard FireTV keys work fine. However, it's annoying to have to use the menu key to access the 5-9 digits when entering the Amazon PIN, so I decided to try getting the numeric keys on the Harmony to send numbers as if it is a keyboard. Now when I press any of these keys on the Harmony remote, the FireTV interprets them all as "0." (Verified through the "view PIN" option on the FireTV.) Here are the steps I took to get where I am: Since the Harmony Flirc/FireTV device profile doesn't have a bunch of extra commands, I added an MCE Keyboard device profile and added it to my "Watch FireTV" activity in the Harmony setup.I then mapped each of the 0-9 buttons on the Harmony to the corresponding commands from the MCE Keyboard device profile, and updated the remote with this setup.I used the FireTV Controller in Flirc to map the standard FireTV keys (using the FireTV "device" on the Harmony), then used the Full Keyboard controller in Flirc to add the numbers (using the MCE Keyboard device on the Harmony).*After pugging the Flirc back into the FireTV and trying a purchase, I got an "incorrect pin" error. I used the "View PIN" option to see that all my numeric keys were being interpreted as "0".*While programming the number keys in Flirc, I kept getting errors that the key was already in use. The only way it would take the number was to erase the key just before programming it. This happened even when I did a firmware overwrite and cleared the Flirc configuration. Should I be using a different device profile or other configuration in the Harmony software? Should I be using a different controller or different method to program the number keys in Flirc?