Jump to content
Flirc Forums

Leaderboard


Popular Content

Showing content with the highest reputation on 03/28/2018 in all areas

  1. 1 point
    Hello all. I had a peculiar issue where my Flirc was receiving a continuous button press. It was like somebody was holding down the up button on my remote. I believe the culprit was my phone's proximity sensor, which is IR based technology. I started testing things in the usual way. I cleared my configuration, switched ports, reinstalled, made sure my firmware was upgraded.. but nothing was working. The only thing that could stop the button input was when I covered the device with my hand. I then thought that maybe I had a faulty remote with a button stuck down, so I removed all of the batteries from my remotes and Flirc was still receiving a signal. I was absolutely puzzled. A couple hours later I picked up my phone, walked away, and the button pressing stopped! I set my phone back on top of my computer and the button presses started up again. I finally figured it out! =D When my phone is within 6 inches of the Flirc it registers a button press. My Flirc is plugged into the USB ports on the top of my case and my phone was resting directly next to it. My phone is a Pixel 2 so I hopped online, did some research and found that the proximity sensor in the phone is IR based. The good news is that the IR interference only happens when my phone is inches away from the device. Keep in mind that your mileage may vary though. I just wanted to share this in case someone else is searching the forums for a related issue.
×